Woodworking Blogs

I won't pretend for a moment the decision to make the windows isn't driven by cost. At a very minimum it would cost 15 grand (sterling) to buy the...

I would love a two car garage workshop, it's my dream to have space for everything including a dedicated  finishing area. I do have a garage, but i...

Of course, I'm not just going to make these windows straight off the bat. I have spent many hours looking into this project, looking at what toolin...

How Sash Windows Work 1. Top Rail: The top horizontal framing member of a sash. Rabbeted (SEE GLAZING BAR) on the outside. 2. Box Frame: Sometimes ...

Part 2 of my Renners information pack Not sure how you edit Blogs so here is the picture and associated parts as described in my text

With all the last minute shaping and sanding complete, everything was ready for the final glue-up.  There's not really a whole lot to show here.  I...

Well, yes! You can use the Ti02 on tile and transfer a photograph over. I personally haven't seriously tried to do this but I have seen pictures o...

My last pair of blanks are for the armrests.  I started by planing them down to 5/8" thick, which is the final thickness for rear of the armrest.  ...

There were a couple things I wanted to verify before the final glue-up: • Could I keep the paracord lacing tight enough so that it would support a ...

It's been a while since I was on here, to my old friends and everyone else, I hope you are keeping well and navigating life's challenges the best y...

Simultaneously aligning all 4 components of a side assembly gave me fits.  Very slight errors in length and/or angles meant that as I sequentially ...

Most of the pressure-treated scraps from my deck skirting project were pretty narrow - around 1-1/8" wide.  Most of the blanks needed for the chair...