Wegner Dolphin Chair #13: Backrest Assembly

20
1

This is part 13 in a 13 part series: Wegner Dolphin Chair

Time to put the new jig to work for the backrest stile mortises.  I started by transferring the centerline for each of the three rails from the stile template to one of the stiles.  (I had previously worked out just where each should be located and marked-up the template.)  Then, I stacked the one stile on top of the other, aligned and clamped them together, and transferred the centerlines across both stiles.


With the centerlines carried over to the inside face, the stiles were ready for mortising.  I started with the double mortise joint of the lower rail.  I adjusted the jig to center the mortises across the face at that position, clamped the stile in place, and routed the mortises.


The jig worked like a charm.  Without changing the jig setup, I loaded the other stile into the jig and cut the double mortise on it as well.


For the mortises for the middle rail, I only used one of the mortising holes.  The edge of the stile protruded into the 2nd mortise hole of the jig, so I taped over the hole as a reminder not to use it.  Because I couldn't bear the thought of the thickness of the tape throwing off the angle of the cut, I put a parallel strip of tape on the other side of the mortise hole.  🤓  With the jig adjusted to center the mortise on the face at this position, I cut the middle rail mortises on both stiles.



After repeating the process for the top rail mortises, the stile mortises were complete.  Time to work on the rails.


Using what I learned with the prototype middle rail earlier (primarily, that I could use a little more room around the weaving slot for fastening the wrapped cord), I increased the depth of the middle rail a little and shifted the line of warp cord holes outwards. 


With the shoulders marked on each of the rails, I setup the Pantorouter to cut the tenons.   I used a fence extension to ensure that the rail was perpendicular to the table, since that technique worked so well last time.  (The fence extension has been removed in these pics.)  Due to the different depths of each of the rails, I had to make a fence adjustment for each rail to center the tenons on the ends. 





Time for another dry fit.




Next I'll work on fastening the backrest assembly to the seat/arm assembly.
lookin real good ross. a lot of template work but it would be hard without em.

working with my hands is a joy,it gives me a sense of fulfillment,somthing so many seek and so few find.-SAM MALOOF.