Wegner Dolphin Chair

4045 views
14 entries

1 Four years later

[spongebob 4 years later.jpg] It's been 4 years since I built the 1:6 scale model of the "Dolphin" chair by Hans Wegner.   Back then, I didn't hav...

2 Router templates

The original design had a notch on the front leg under the seat that was a stop for the folding chair.   Since that notch would serve no purpose in...

3 Lumber Prep

Last year I got a good deal on Marketplace for an assorted stack of white oak planks.  I used some of it on the hot tub chair, and will use it on t...

4 Shaping the Main Parts

I'm no stranger to using router templates for flush trimming, but I white-knuckled it with these chair parts.  The long curves meant the grain dire...

5 A Pause to Plan

I was out of town for a few weeks, and wasn't able to be in the workshop.   But I was able to brush up on my Fusion skills and start modeling the f...

6 Mortise and Tenon Jiggery

For all the mortise and tenon joints between the sides and stretchers, I decided to go with integral tenons cut on the Pantorouter.    Unfortunatel...

7 Mortise Jigs for the Seat Stretchers

I'm focusing on the seat components first so I can work out any kinks in the M/T process.  The components that form seat sides have a single mortis...

8 Seat Stretcher Tenons

I cut a set of stretchers on the CNC since its bed was large enough to accommodate their length.   It's much less harrowing than flush trimming nar...

9 Arm Yoke Stretcher

For cutting the yoke tenons, I used the technique described by Ty earlier, rather than using a filler piece in the top curve of the yoke.  Ultimate...

10 Arm/Seat Rail joint

Back when I was flush-trimming the arm and seat rail components, I avoided routing the straight edge on each where they would eventually be joined....