Craftisian

LIttleBlackDuck

3865 posts and 46 followers
in almost 2 years
0
0

Mini Office Workbench #10: Threading, bolting and rubberising the cookies

402
0

This is part 10 in a 13 part series: Mini Office Workbench

  1. Introduction
...
  1. Sanding the cookies
  2. Threading, bolting and rubberising the cookies
  3. Drill the side clamp holes, finish cookies
...
  1. Epilog 

Boys and Girls,
                                                                                                     
Chose to cannibalise some threaded rod,
using my cordless bandsaw,
 
With the Wood Whisperer’s threader the cookies got screwed,

and the thread was tested,

cookie position marked,
(running out of commentary after 9 episodes)… 
 
The mark was centre punched using my Veritas gizmo,
 
The bolt was epoxied in the thread and the rubber matting “under” the cookie,
 
 Just a tad more detail has been presented in this video,


 

If your first cut is too short... Take the second cut from the longer end... LBD

mini kapex workbench mft style dog holes ujk parf tracksaw bench dogs holesaw parf dogs parf revision dogs foam matting tct holesaw bi-metal holesaw disc sander circle cutting jig wood whisperer wood tap

More from LIttleBlackDuck

BOOMBY or an OGWOOFY! Gardening and vino… Create a series #2: Follow up series Create a series #1: Part 1 My Laser Adventures.
RSS