workbench

Well this will close up this blog on my journey building this Robou Hybid Workbench. When I started I wanted to be able to hold and clamp wood in o...

First stab at a worktop workbench, I'll make a better one if i use it much. So going in I wanted it to be cheap (well, free), so I made the dimens...

For over 15 years now I have been working out of my garage as a workshop without a carpenters vise or a dedicated carpentry space. The shop has pro...

Well after a few days off I started back up on the workbench/outfeed table. I have the cabinet carcases done except 1. I have two 12"×18", (1) 18"×...

Outfeed workbench – under $150 I had hoped to keep this bench under $100 but I think maybe I’m just too frugal (spelled c-h-e-a-p)! The main portio...

Boys and Girls,                                                                                                       I slapped on my shiny new yel...

Well ladies and gentlemen im feeling much better again. And its Hammer time. Time to start making up time lost from being sick. First, I just wante...

Just a quick note where im at. So far I have taken raw hickory that was stright line ripped and skipped planed to the mitersaw made all my rough le...

Hello ladies and gents, well I’ve been busy making Doors, drawer fronts & tons of sanding. Well after sanding, I put on two coats of tung oil w...

I found some hardwood at a local lumber middleman, none of our mills have any type right now and might not until spring. I even had to order this b...

Well it’s Valentines day and I only got to work a few hours today. So I ripped my frenchcleats today. Im using the back of the workbench for storin...

Glue up the sections of the top. [20230329_165730.jpg] Then just give it a final flatten. [20230329_170116.jpg] [20230329_171407.jpg] [20230329_...