Rhoots

Fitted the braces and reinforcing ring to the inside of the soundboard. [IMG_2648.jpeg][IMG_2650.jpeg] Fitted the soundboard to the body. I suppose...

The soundboard is Master Grade Sitka Spruce. Came in rough at about 3/16" thick. I glued the book matched halves together the cut out the oversized...

Back panel glued-up and trimmed flush to the sides. [IMG_2634.jpeg][IMG_2635.jpeg][IMG_2637.jpeg] Installed soundboard lining and sanded flush to t...

Installed the linings for the back panel and sanded flush to the sides. Laser cut the back panel and all the braces. When I get my 120 grit sand pa...

Jig Setup I set up the assembly fixture using the body template, and fixed the neck position.  [IMG_2612.jpeg][IMG_2613.jpeg] Check the Side Fit ...

Been a while since the last update.  I went a little crazy last week and picked up a Jet 1020 thickness sander. The local supplier had it on a cle...

First thing was to glue the head veneer to the head. This is a solid piece of Black Walnut about 1/8" thick.[IMG_2588.jpeg] Once the glue dried, I ...

Assembled and roughed-out the neck. Material is reclaimed Tulip and Black Walnut [IMG_2579.jpeg][IMG_2580.jpeg][IMG_2581.jpeg][IMG_2582.jpeg][IMG_2...

The design for this project is mostly complete. Just need to add the action layout to the setup layer but that can wait until much later. I got a r...

I found this article in the Spring 2023 issue (number 148) of American Lutherie. According to the article, this is an instrument that was one of th...