Woodworking Blogs

view blog series
 I wanted to use glue to attach the pyramids to the disks, because I didn't want any visible fasteners. But it was very apparent that I would need ...
Before I could apply finish to the disks and attach the pyramids, I had to iron out the details of how to attach the three outer support wires. Th...
 I had an old scrap walnut board with lots of character that I thought would be perfect for this project. I had hoped I could resaw it in half so I...
Now that I knew I was going to use beading wire with crimp-secured end loops, I had to decide how I was going to connect the two pyramids. (I decid...
 Early on, I was pretty sure I was going to use some kind of wire to hold the table together. I remembered working on a craft project with my daugh...
 Finally, I was ready to start cutting the side segments, starting with the top ends. I clamped the template to the sled with its vertical edge ali...
 Before starting to cut the pyramid segments, I cut/built some templates from the second half of the maple board I resawed and planed for the pyram...
The first step in building the pyramids was cutting the angled strips for the segments. [Tensegrity Tetrahedral Table - Parallelepiped Dimensions....
This is a blog of making a classic car I hope you will enjoy it. Questions and comments are more than welcome. There is also a breakdown vid made...
This week or next I will begin the process of refurbishing a Harbor Freight folding trailer I purchase several years back. Original Build Build Sta...
This is a blog of making a classic car. I hope you will enjoy it. Questions and comments are more than welcome. There is also a breakdown vid: ...
During making the Buick Sedan I have made a lot of pictures and they will be used for this blog about the build process. This blog is mostly made i...