My tablesaw is a right tilt Unisaw with an Incra fence on the right side. When I need to make a cut with the fence on the left side of the blade, such as a bevel cut, I need to get creative.
The Incra fence can be set up on the left side temporarily. It's not as simple as a Biesemeyer or similar fence, it takes too much time for me.
I made a fence that is secured in the Incra fence rails with carriage bolts. 3 layers of 3/4" MDF. 2 & 1/4" x 3" x 34".
It takes a few minutes getting it in the right place and square to the blade. Much less time than my other option.
Hey, you don't know me, but you don't like me ... Buck Owens
I thought that ,too. It's the way it's made. It would work, but I'd have to go to the other side of the fence to set it. The Incra fence takes up a lot of room on the right side, that's why a lot of folks don't like it. I don't have the room on the left side to make it permanent.
Hey, you don't know me, but you don't like me ... Buck Owens
I have one on my saw. Love it, but I get it, it does take up room. That’s one reason why I bought the long rails. To make a wide cut I’ve got to open the garage door for the fence arm to slide out. And you would have to change everything over thought-process wise to a right sided cut. Whatever works!
Ryan/// ~sigh~ I blew up another bowl. Moke told me "I made the inside bigger than the outside".
Don’t know if you care to consider it, but if I was making such a thing I’d use a couple T-bolts through the fence to grab the rails, with knobs to tighten down against them. Wouldn’t require a wrench that way and would make adjusting a bit faster maybe, but I don’t suppose it matters that much. What works, works!
Ryan/// ~sigh~ I blew up another bowl. Moke told me "I made the inside bigger than the outside".
These may cost a few shekels more than a nut, however, since you bought the Incra fence, I'm assuming convenience is a greater priority.
They are both available from Rockler (cost a bloody fortune shipping to Aussieland)...
The knob is a slip knob that's great for long threaded rods when you need to physically remove the knob and not just loosen. The other gizmo works on a cam system and a breeze to select the appropriate force, without tools... I think there's an Incra version, hmmm, not sure as there is no branding... though more the Woodpecker$ colour.
If your first cut is too short... Take the second cut from the longer end... LBD
