Woodpeckers Router table free hand guard

627
6
 
 one of the members on lumber jocks dw (desert woodworker) posted this, when i saw it i went and ordered immediately. it is made to attach to woodpeckers lifts with two threaded knobs but can be retrofitted to any lift by simply drilling and threading a couple holes. a real simple guard that eliminates a starter pin. it has a 2-1/2" opening that you can just plug your shop vac into. trying it out id say it sucked up a good 98% percent of the dust. cost is 39.99 not bad for what it does for free hand routing. i wish i had this years ago. this was posted and moved from lumber jocks.

working with my hands is a joy,it gives me a sense of fulfillment,somthing so many seek and so few find.-SAM MALOOF.

Pottz,

one of those came with my router table as a package from the local woodcraft store (long gone)  I have never used it.

I will youtube to see what the uses are.


Petey

i used it when i first got it but not much lately. it worked pretty good though collecting dust you normally couldn't.

working with my hands is a joy,it gives me a sense of fulfillment,somthing so many seek and so few find.-SAM MALOOF.

When did we get a Tool review section????

Ryan/// ~sigh~ I blew up another bowl. Moke told me "I made the inside bigger than the outside".

who said we did ? 🤔😏

working with my hands is a joy,it gives me a sense of fulfillment,somthing so many seek and so few find.-SAM MALOOF.

Well, you’re posting on it. The stars give it away. 

Ryan/// ~sigh~ I blew up another bowl. Moke told me "I made the inside bigger than the outside".