Share your craft projects
Make new craft buddies
Ask craft questions
Blog your craft journey
RobsCastle
838 posts
and
21 followers
in about 9 years
in about 9 years
Cable Drum Table Top Pt 2
Here is the progress so far:-
1. Routed the edge and rounded it over.
I used a straight bit with a top bearing deep enough to do the job.
The round over was a 5/8 round over bit
2. Cut plugs for the1 x 38 mm and 4 x 32 mm holes with respective size hole saws, you may notice the pilot bit was removed. I used a , and dowel for the 8 x 6 mm holes in the top side only. Once the glue was dry I used a trimmer to profile the tops of the plugs flush.
3. That worked out OK so I commenced the second table top.
1. Routed the edge and rounded it over.
I used a straight bit with a top bearing deep enough to do the job.
The round over was a 5/8 round over bit
2. Cut plugs for the1 x 38 mm and 4 x 32 mm holes with respective size hole saws, you may notice the pilot bit was removed. I used a , and dowel for the 8 x 6 mm holes in the top side only. Once the glue was dry I used a trimmer to profile the tops of the plugs flush.
3. That worked out OK so I commenced the second table top.
Regards Rob
4 Comments
Do you plan to band the edge?
The Rockler Steamer is a good little unit for bent people and rumors have it you fit the bill.
The Rockler Steamer is a good little unit for bent people and rumors have it you fit the bill.
If your first cut is too short... Take the second cut from the longer end... LBD
good start RC.
working with my hands is a joy,it gives me a sense of fulfillment,somthing so many seek and so few find.-SAM MALOOF.
Yes LBD your banding suggestion is going to be implemented.
Sadly no Rockler Steamer for me just some latex stretchy stiff
Regards Rob
rc, did you
Holesawing with ease and without the tears
and for those that hate to read just as much as I do....
Didn't notice any extra holes!
Didn't notice any extra holes!
If your first cut is too short... Take the second cut from the longer end... LBD
