RyanGi

Just a short entry, maybe almost just an addendum…. I swapped out the table top on the Auxilary bench for a 2’x4’x3/4” thick chipboard covered wit...

In this installment, I'll be talking about the actual implementation of the vacuum clamp, successes and failures, and what I plan to do next... As...

This entry is going to focus on the bits and bobs that turn the venturi pump from a pump into a workholding device. This one rambles a bit, so get ...

This entry will focus on the assembly of the V4 veneer vacuum kit from VeneerSupplies.com. I spoke about the choice of this pump in the first entry...

[EBD9FCF0-9EDB-411E-AEA3-C663E790B6FB.jpeg] During a discussion here a few weeks ago, the issue of vacuum work holding came up. That's intriguing ...

Until the Review section gets built up (no rush Martin!), I figured I’d keep my reviews contained to one blog series. This will serve as the into t...

This is my project write up for the 2022 Screwdriver/Marking Tool Swap originally submitted over on another site. The project is basically in three...

This is a review I posted a while back on the other site, I thought it might be of interest for some folks here…. ________________________ I've ne...

I have just finished up and shipped my project for the LJs 2022 knife swap. This was a first for me, as I’ve never made a knife before…well, I stil...