Woodworking Blogs

Just some more progress photos as I completed the upper right quadrant. [20240329-IMG_8956.jpg] [20240329-IMG_8957.jpg] [20240330-IMG_8958.jpg] [2...

 I installed the shelf in my daughter’s house last week. I knew I had measured, and re-measured the wall and electrical panel the last time I was t...

Armed with a new circle-cutting tool, I thought it would be smooth sailing cutting out the balloons and the outline rings.  Nope.  There were two t...

While waiting for the circle cutter to arrive, I identified the boundaries for another independent module I could assemble - the cluster underneath...

Initially, I didn't plan to make any blog posts for this project because I didn't know if it would work out or crash and burn (still don't). But si...

In the near future, I'll be building a sliding panel similar to what Ron Stewart did here.  In my case, I thought I'd try to make the panel a sort ...

 When I “finished” the project two months ago, I noticed that the panel face was very slightly concave. Here, I’ve placed a 36” long straight edge ...

I got the bulk of the work finished up this weekend.  I started with a dry fit of the case and then used it to cut the door members to length.  The...

If you remember "The Gable Built-Ins" blog from that other site (Jan '22), this picture should look familiar. [IMG_3675.JPG] Well, with the extrem...

Seems like no matter when I start a project it never gets done before it has to...  Progress has been slow the past couple weeks.  One weekend we h...

After about 2-1/2 months, the cabinet is finished and ready for use.   Media cabinet project summary: • Baltic birch plywood with Izombe veneer an...

I've been looking for a kerf extender for playing around with half-blind dovetails.  The one from Cosman is $129.  I'm sure it's top-notch, but too...