Is it just me?

1166
19
Whats wrong with this picture?

Figuring out how to do something you have never done is what makes a good challenge.

19 Replies

backwards saw blade

You don't always get what you go after,but you do get what you wouldn't have got if you didn't go after what you didn't get. Blaze Foley

At first glance it looks like the saw is tilted upwards, but as I look closer, I think it's cutting at an angle.  Other than that, I don't see anything weird.

Half of what we read or hear about finishing is right. We just don’t know which half! — Bob Flexner

I don't know why you'd need a cold saw for wood, but sure lol

MosquitoMade.com

i dont see much wrong either, but whats a cold saw ? meant to cut ice !!!!!

working with my hands is a joy,it gives me a sense of fulfillment,somthing so many seek and so few find.-SAM MALOOF.

For cutting cold steel?  If that's the case, why show it cutting wood?

Hell I don't know.  I'm just guessing.

Half of what we read or hear about finishing is right. We just don’t know which half! — Bob Flexner

ok bent whats with it ?

working with my hands is a joy,it gives me a sense of fulfillment,somthing so many seek and so few find.-SAM MALOOF.

Clearly you all aren’t aquatinted with the State Saw of California. Guaranteed to cost you twice as much, work half as hard, and be built wrong to begin with…some assembly required…obviously…

Ryan/// ~sigh~ I blew up another bowl. Moke told me "I made the inside bigger than the outside".

The teeth where it's cutting into the wood are carbide, but look at the bottom of the blade.
What is this a multiple use blade?
Or are they just hidden by the guard?  (I just saw that)lol

Figuring out how to do something you have never done is what makes a good challenge.

My bad...

Figuring out how to do something you have never done is what makes a good challenge.

buddy i see 1 tooth plus a half ! i dont know what your seeing ?

working with my hands is a joy,it gives me a sense of fulfillment,somthing so many seek and so few find.-SAM MALOOF.

Down at the bottom, right above the words,  I thought that part of the blade was a masonry blade 
(because of the expansion slot I guess.)  
Don't mind me I'm off my medicine....

Figuring out how to do something you have never done is what makes a good challenge.

working with my hands is a joy,it gives me a sense of fulfillment,somthing so many seek and so few find.-SAM MALOOF.

If you zoom in close enough on the blade you can see an image of Elvis.  It’s there, I swear it!

Half of what we read or hear about finishing is right. We just don’t know which half! — Bob Flexner

no rich look closer................it's jesus !!!!!!!!!!!!

working with my hands is a joy,it gives me a sense of fulfillment,somthing so many seek and so few find.-SAM MALOOF.

you have to spin it backwards to see Jesus,

Figuring out how to do something you have never done is what makes a good challenge.

"I buried Paul."

It's real.  I did it on my LP.

Half of what we read or hear about finishing is right. We just don’t know which half! — Bob Flexner

Yeah, that's way wrong and the hex is all boogered up too.  Grabbing whatever hardware is handy doesn't apply to a situation like this.
My question would be: "Why is the saw set to cut so deep?"

Mike

Yooper with a Drawl

framers always set the saw at it's deepest no matter what they cut. changing the depth would take too much time when your making hundreds of cuts a day.

working with my hands is a joy,it gives me a sense of fulfillment,somthing so many seek and so few find.-SAM MALOOF.