Share your craft projects
Make new craft buddies
Ask craft questions
Blog your craft journey
Dave Polaschek
1833 posts
and
44 followers
in about 2 years
in about 2 years
Tiny Vix bits?
I’m looking for a Vix bit for #0, #1, and #2 screws. The smallest SEVick seems to make is a #3 with a 5/64 bit, but I need something with a 3/64 bit. Or a 1/16 and wood glue to make the screws less sloppy.
I can make the pilot holes with an awl, then my pin vise with a 3/64 bit, but being even a 1/16 off-center kinda looks bad. And I’m working in maple at the moment, so I need to make pilot holes or risk snapping off screws.
Anyone know where I can find such a beast? McMaster-Carr only sells down to 5/64.
Thanks!
I can make the pilot holes with an awl, then my pin vise with a 3/64 bit, but being even a 1/16 off-center kinda looks bad. And I’m working in maple at the moment, so I need to make pilot holes or risk snapping off screws.
Anyone know where I can find such a beast? McMaster-Carr only sells down to 5/64.
Thanks!
May you have the day you deserve!
8 Replies
same here smallest ive seen is the #3
working with my hands is a joy,it gives me a sense of fulfillment,somthing so many seek and so few find.-SAM MALOOF.
I got mine at Lee Valley but same story 5/64 is the smallest.
The early bird gets the worm but its the second mouse that gets the cheese.
What about a number index, I don't remember how small they make them, just know it's small. I have an index with fractions, alpha and numbers.
Main Street to the Mountains
They're not Vix bits, but they are designed to center the bit, and the smaller bit is 3/64" (1.18mm).
https://www.woodcraft.com/products/highpoint-micro-center-bit-set
https://www.woodcraft.com/products/highpoint-micro-center-bit-set
Half of what we read or hear about finishing is right. We just don’t know which half! — Bob Flexner
Thanks, Rich! Those sleeves look like something I could make in the shop, even. I might have just found my next project!
May you have the day you deserve!
Thanks, Rich! Those sleeves look like something I could make in the shop, even. I might have just found my next project!
Awesome, Dave!
Half of what we read or hear about finishing is right. We just don’t know which half! — Bob Flexner
I think I have just changed out the bit to a smaller one. I know I have changed the bit so I can put in a Brusso hinge (their screws) which get stripped easy.
Petey
I tried changing out the bit, Petey. The 3/64 bits I have are too short, but worse, I can’t snug the set screw down enough to hold them reliably. It might hold a 1/16 bit, but it definitely won’t hold a 3/64.
May you have the day you deserve!
