Brian

Throw me in for a chance at the $100. Not much to show here compared to some of the ones I’ve seen. My shop is about 10′ × 20′ with a 7’ ceiling. P...

I’m exhausted. I built this over the past 2 days which is a day too long. I wasn’t sure about the height and had problems making it fit the swing t...

I have an old delta contractor saw. Underneath was a pan tilted about 45° to the back to let the dust drop and sort of keep it away from the front ...

Last jig for a while. I promise. I made a finger joint jig today. This one is for 1/2" joints. I started by making the key. That took about 20 pass...

Fresh on the heels of my mitre sled comes this spline jig for box corners.

Today I made a new mitre sled. I made one a while back and used it this morning. To my great disappointment, the small triangles I cut were not per...

OK these mistake drawers retrofit into wood slides are finally done. I just need to lubricate the slides and fill the drawers up. I was going to si...

I had some free time this afternoon so I decided to make some drawers for one of my shop cabinets. I designed them weeks ago, carefully taking meas...

Today I made some more progress. Got the flip top cabinet made for the planer. I designed the cabinet but made the support/table on the fly as I ca...

Stupid tape measure. Always proving me wrong. I got my first box make and installed, which was for the CMS. I needed to get that thing off the floo...

I really need to make a table for the CMS because I have a bunch of house projects that will require it. I just picked up 5 sheets of 3/4 pine plyw...

I’m very tight on space. My original plan did not allocate room for a garbage can and only partially for dust collection. I think I’ve come up with...