Woodworking Blogs

 [12.13 - Finish and Assembly - Finished Rack.jpg] With the brace finished, the rack was almost ready to assemble. I started by adding the top cap...

Before I started working on the cart, I decided it was time to address a problem I had been deferring. The racks pivot on 3/8” dowels, with a washe...

 [02.07 Design - Cart Details.jpg] With the washers sorted, I started on the cart’s base. The base is a panel with a skirt, an upside-down, open b...

 [02.07 Design - Cart Details.jpg] The support brace is a large open triangle that connects the cart’s base and rear panel. The top of the brace ...

[02.06 Design - Rack Details.jpg] In preparation for assembling the racks, I prefinished their interior sides (no pictures of that) along with the...

I'm going to start off by admitting I'm guilty of procrastinating on getting this posted.  I kept telling thinking of one more thing that I wanted ...

It's time to make the wings! [image.png] [image.png] Lets start with a nice piece of straigth oak. I'll be using a old bed railing. It dry and will...

Giving the head a fist layer of green paint, some small details will be white. [20230915_180208.jpg][20240518_121518.jpg] And a first coat for the ...

  [07.00 Magnets - Rendering.jpg] With the spool blocks and tilt stops shaped and sanded, it was time to start thinking about the magnets that woul...

  [02.02 Design - Spool and Bobbin Blocks.jpg] When I last worked on the spool blocks in Part 2: Starting on the Spool Blocks, they had rectangul...

The next parts to be made are a beam for the breaking system of the mill, some rafters and the cladding. On the drawing that would be these parts: ...

Apologies to the Doors! [IMG_0165.jpeg] Finally the finish has been sprayed. Base coat is Mohawk vinyl sealer, top coat satin pre-cat lacquer. Pr...