Old post vise

205
9
I need to change my ways. This old heavy stuff keeps following me home.



I want to mount this to a 4" steel i beam post in my basement.  Any help is appreciated. 

18" wide at top, 40 " tall, 4.5" jaws.

There's roosters laying chickens,and chickens laying eggs... John Prine

We had something like this on the farm. I'm trying to remember how it was mounted.

Are you going to clean it up? Paint it?
I will clean and get it lubed good, I doubt it will see paint.

There's roosters laying chickens,and chickens laying eggs... John Prine

IIRC, Duckmilk made something for mounting his on his metal working bench.  

--Nathan, TX. Hire the lazy man. He may not do as much work but that's because he will find a better way.

My first thought was getting a wood 4x4, and strapping it all to the post.

There's roosters laying chickens,and chickens laying eggs... John Prine

There is typically something that looks like this that clamps it to a bench or beam.  

--Nathan, TX. Hire the lazy man. He may not do as much work but that's because he will find a better way.

Nathan is right, I bought one without the spring or mount so I made them. These vises were designed to be attached to a flat horizontal surface, not a post. I don't use the post term, I call it a leg vise.

I got fancy with my mount but it doesn't have to be. This one wrps around the rear jaw and bolts onto the bench top incorporating two wedges to hold it tight. It also holds the top of the spring.



Here is a view of the wedges and spring. Also, the screw cap or nut would interfere with mounting it to a vertical surface.


This is the first leg vise I bought that was complete. You can see the U with wedges is a separate piece from from the bench mounting part.


These are great, strong vises Hairy. I have bent steel clamping it in the jaws and hammering on it.
Remove the screw from the nut and grease it for smother action.
I curious about the coil spring on yours, most originals used a S shaped flat spring.

"Duck and Bob would be out doin some farming with funny hats on." chrisstef

Plan B could be attaching it to the wall. There is a structure to support a 6 x 12 i beam.




Best 2 options so far.

There's roosters laying chickens,and chickens laying eggs... John Prine

One other thing to consier since you have concrete foors Hairy, if you notice at the bottom of the leg on your vise, there is a ring about an inch or so from the bottom. That is to keep the leg from sitting totally on the floor and absorb shock. Look at the bottom of the first pic I posted. there is a twobafor with a hole drilled in it to keep the leg from hitting the floor, a short piece of steel pipe will work too.
Whatever you do, keep the screw portion away from a verticle post or wall. It will give you more room to clamp and work on things in the vise.
Eventually, I think you will want a bench to mount it to, more space and more flat surface to accumulate junk that will just get in your way.😆

"Duck and Bob would be out doin some farming with funny hats on." chrisstef

I have seen quite a few in use, always in an old post and beam barn, and mounted soundly to a shelf, or like Ducks, on a bench secured between sound timbers. I think you could fashion a wooden form that could mount to your post. How well it held still is gonna be the question? In use they scream for an inventive mind to mount them. I don't know if any of the ones I have seen were purposed for woodworking as a first use. Holding Ferrier work, and a lot of welding stuff. Probably due to lack of wooden jaws. By the time those metal jaws got a good grip on a piece of wood, they usually would have dented it up quite a bit.