Share your craft projects
Make new craft buddies
Ask craft questions
Blog your craft journey
Jeff Vandenberg
1345 posts
and
50 followers
in almost 10 years
in almost 10 years
Serving Bowls #1: Bowl glue up.
This is
part 1
in a
3 part
series:
Serving Bowls
-
Bowl glue up.
-
Routing Out the dish
- Bowl glue up.
- Routing Out the dish
Well starting some new bowls or serving bowls from the patterns I picked up at the wood show. Here is a glue up of 2 inch thick white oak that the moisture content was 13%. So I used the gorilla glue on one edge just ran a damp Towle down the other edge and glued it up. Not much foaming. I do know how sometimes it can get carried away and foam all over.
I’ll update as I go. I’ll be making a bunch of different types.
Jeff Vandenberg aka "Woodsconsin"
8 Comments
Hehe… That’s way cleaner than my panel glue ups with gorilla glue. In embarrassed to show you a picture. ;-)
Losing fingers since 1969
Post the picture here Brian. Come on let me see.
Jeff Vandenberg aka "Woodsconsin"
Great glue for ‘waterproofing’ joints Jeff and they say it doesn’t creep either. I have used it in on several outdoor projects and it holds up extremely well over the years. The only problem I had with it was that the even though sealed, it dried up in the plastic container relatively quickly, so maybe best purchased in small quantities, unless there is some way to stretch it’s useful life that I don’t know about.
Mike, an American living in Norway
Jeff I have never used gorilla glue and just wondering if it has any advantages over regular wood glue? Also does the moisture content have to be at a certain point before you use it? Thanks in advance for any information.
Jack
They recommend wetting the surface before gluing. So if moisture content is low, then you need to bring it up the old fashioned way – lick the board. LOL I just imagined getting splinters in my tongue.
Also good for wood with high oil content.
Losing fingers since 1969
Thanks Brian, I’ll try that.
Jack
Jack you can use that gorilla glue on any moisture level. The thing that I personally follow is I stay away from your wood glues above 12% moisture content. And use the gorilla glue because its activated by moisture. If my wood is at 8% moisture and I run a damp rag down the wood acts like a wick and the grain raises. Now your joint isn’t true anymore. Please don’t get me wrong as the joint will still fit but there are imperfections in the joint. But at a higher moisture content getting closer to that 20% ive actually used gorilla glue without any water and it activated and the joint glued just fine. Weird by the slightest moisture and the glue activates. Here a lesson learned don’t put the brush back into the bottle. The moisture thats picked up out of the wood gets on the brush and if you keep dipping the brush in it activates the glue in the bottle.
Jeff Vandenberg aka "Woodsconsin"
Great information !!!
Jaybird
