Share your craft projects
Make new craft buddies
Ask craft questions
Blog your craft journey
Thorreain
1908 posts
and
47 followers
in over 10 years
in over 10 years
Box spline sled
Just about finished this. It’s a jig for putting edge splines in boxes. I am awaiting knobs to put stops on the edge of the front. It’s made from scrap oak and scrap oak plywood 3/4". It works very well.
CHRIS, Charlottetown PEI Canada. Anytime you can repurpose, reuse, or recycle, everyone wins!
9 Replies
Hmmmm. I like this. I could see it’s adaption to the router table. Good job!
Keith "Shin" Schindler
Good job.
Boyne
Simple and elegant.
-- Alec (Friends call me Wolf, no idea why)
I made one too.
I am not sure where you are going to use the knobs but I will wait for the finished version.
Abbas, Castro Valley, CA
The piece of end grain plywood that sticks out 2" on the 45. I will make a couple of “U” clamps to fit around the 3/4" and put the knob thru the top of the u with blind nuts on the back of the u. It will be like a big C clamp sort of, they will be able to slide the whole width and compress the piece holding it in place. The first pic shows the wood that the “U” will fit onto.
CHRIS, Charlottetown PEI Canada. Anytime you can repurpose, reuse, or recycle, everyone wins!
I like the idea of adjustable stops. Gonna have to buy more plywood, so I can make one of these. :-)
Keith "Shin" Schindler
Nice job. There have been a few of these posted lately. It’s great when that happens so the next guy can take the best of all the designs. Continual improvement. I know I would have done mine differently if I saw these others first.
Losing fingers since 1969
Yeah, keep posting I’m getting ready build one.Seriously, nice job Thorreain!
Did you think about doing angled splines?
The alternated angle spline look pretty hot.Resembles dovetails.
steve66
nice jig and a fine looking table saw you have their
TWS
