Share your craft projects
Make new craft buddies
Ask craft questions
Blog your craft journey
Jay
223 posts
and
10 followers
in almost 10 years
in almost 10 years
The Shop, saw stations #1: The Shop, miter saw station
This is
part 1
in a
5 part
series:
The Shop, saw stations
I used mostly pallet wood, the back, floor & drawer bottoms are made from 1/4 " paneling from partition walls that I removed from the shop, also the electrical & 2×4′s for the base. I used up a lot of scrap plywood.
The industrial supply down the street from my shop discarded office work stations that I used for the tops.
The switch near the miter saw controls both saws & the dust collector .
The pic of one end shows the hole for the vacuum hose and electric for dust collector.
The 2 large drawers will be for small scraps, one for fire wood, the other for hardwood & other usable pieces. There are 2 shoots next to the miter saw.
There are 3 slots at the back for 3 to 6’ scrap pieces & 3 shelves for 18" to 24" scraps.
I will eventually put on drawer fronts when I find just the right material.
More to come.
Jaybird
9 Comments
Nice station Jay and great reuse and recycle.
Jack
nice work station
jim
Thank you both !
I have always been pretty conservative & I recycled a lot, but it’s funny how my mind set changed after I retired.
Less income & a little more time makes a difference. LOL
Jaybird
Nice work. Beautiful shop too.
Losing fingers since 1969
Thanks Brian !!
Jaybird
Hi Jay… Like what you have done. Looking at all of the recycled wood, I thought, “This dude get his supplies at the same place I do”. Noticed the HD shielded cord coming out of the wall fixture. I assume this cord supplies power to all of the outlets in your new work station. Great job!
Thanks Mark, I like saving money on recycled, more money for tools.
Also, I like the rustic look.
Yes, there are 3 outlets, 1 for each saw & 1 for the vacuum. The switch near the miter saw controls all three. That way the vac has to be on for the saws to work.
I getting ready to post more pics on the radial saw station.
Jaybird
I did something sort of similar. I wired an outlet to my tablesaw switch and plug the vacuum into that switched outlet. That way the vacuum always comes on with the saw. I upgraded the switch and the power chord too, to handle the extra amperage.
Losing fingers since 1969
Brian, I guess great minds work alike.
I have a real old table saw without the new safety switch.
So I rewire to allow the dust collector to come on with the saw.
Jaybird
