The next parts to be made are a beam for the breaking system of the mill, some rafters and the cladding.
On the drawing that would be these parts:

The break beam (vangstok) is used as a big lever to tighten and release the break (see part 27)

It has a small disk in it for a rope, a hole for the metal band from the break and a pivoting point

C

There is just enough room to fit it all together
Next up i will be making the rafters

Using my small band-saw to get them at rough dimensions

And using the belt-sander to refine the shape

Glueing it in place with some squares and rubber-bands

Adding the front framing

And two back braces

The only reference for those two braces is the one brace on this drawing, they can't be found on the cross section.
And because there is almost no room i hesitated if the drawings where correct.

But it all fits!

Making a template for the back and transferring it to a piece of wood

Adding the doors

Adding the hinges and latches to keep the doors closed

Glueing the back

Adding the sides

Using the CNC to make a engraving

And another glue up

Same for front

Adding additional rafters so the roof can be lifted off and the inside of the mill can be
seen and accessed

The planks for the roof are fitted to the extra lose rafters

The front finished

And the back