Speaker Enclosures

12832 views
9 entries

1 Finally building the center channel enclosure

Well it tool my long enough but all the other side projects I had on the go are about to wrap up so I can finally get back on to this build. Back i...

2 Back panel and kerfs

Well that took a while…… Kerfing the front panel for the 2 matching corners was a pain but I think it will work quite well. I got the back panel wi...

3 Bracing and port

So tonight I didn’t have much time to work with but got a good chunk done. The corner bracing was made from a template and rounding them all over. ...

4 Front mitered and more bracing

So had a few minutes to get some more small things accomplished. 2 more braces and 45ed the top edge of the front panel.

5 Bendy wood

Finally got around to wrapping the front face onto the base and flush trimming the top panel. The top is just set in place right now as it need som...

6 Speaker in and wired up

Not a huge update but finally got the top on and all the sanding done. As well as cut and rounded over the port, mounted the crossover, ran wonder ...

7 First coat of stain

First of many coats, this fit really take a few to get it where I want it with the ebony stain. 1st coat 2nd coat Oh and the Chardonnay panels are ...

8 Half done poly

Poly Coat #4 is in the books. Now switching to satin and 400 wet sanding.

9 Complete and wired up

Finally got this thing complete and tested it out. It sounds great and goes a lot lower than I expected.